Hi everyone
It's been a while since I last posted. This question is for those who have already been down this road, or those who obviously know more about electronics and controls than I do. I plan to use servo motors (https://www.oyostepper.es/category-89-b ... tores.html) on 3 axes of my IH milling machine, that's for sure. However, I'm also preparing for a fourth "A" axis. My question is. Can servo motors and stepper motors be mixed and controlled by a drive and Mach3? I considered using a stepper motor for the "A" axis. Or is this a no-go?
It's been a while since I last posted. This question is for those who have already been down this road, or those who obviously know more about electronics and controls than I do. I plan to use servo motors (https://www.oyostepper.es/category-89-b ... tores.html) on 3 axes of my IH milling machine, that's for sure. However, I'm also preparing for a fourth "A" axis. My question is. Can servo motors and stepper motors be mixed and controlled by a drive and Mach3? I considered using a stepper motor for the "A" axis. Or is this a no-go?
Statistics: Posted by Alan11 — Sat Nov 09, 2024 3:47 am